V28 Smart Locks screen overhaul

← Back to Properties

The V28 Smart Locks screen was overhauled in

Integration-aware tabs

Each property's Smart Locks detail view now shows tabs scoped to the property's integration:

• Nuki-only property → tabs: Lock Control / Codes / Activity Log / Charging / 2N QR shown but disabled.
• 2N + Nuki property → all tabs enabled.
• Property with no lock integration → the screen shows a setup prompt instead of empty tabs.

Earlier the screen showed 2N QR tabs on properties without 2N — misleading (a bug the overhaul fixed).

Activity log redesign

Now merges into ONE unified log per property:

• Nuki lock events (unlock, lock, activity via webhook)
• 2N intercom events
• Admin actions (code create, code revoke)
• Automation actions (auto-provision, auto-revoke)
• Lock faults — previously invisible; the Errors filter was dead. Now nuki_failure_alerts merges into the feed with a ⚠ fault chip.

Filter chips at the top: All / Access / Admin / Automation / Faults.

Charging tab

Charging history is:

• Merged with activity log — battery events show inline in the main feed.
• Filter-scoped — the Charging tab pre-filters to battery events.
• V28-native panel — replaced the embedded legacy ChargeHistorySection with a V28-styled panel (finally closes.

Multi-lock status

Some properties have multiple locks (main door + garage). The Smart Locks card now shows per-lock status:

Vydrica · main door: LOCKED (95%) · garage: OFFLINE

Earlier only the first lock's status showed.

Faults chip in activity log

Any lock failure — invalid PIN attempt, 5xx from the Nuki API, timeout, wrong-fingerprint — surfaces as ⚠ fault in the activity log with the reason. Operator can filter to see fault-only history.

What was fixed alongside

• ** no longer wear the "Denný sumár úloh" header + generic label; each fault gets a distinct label.
• **